9
9.23
9924871 R03 - 2014 Polaris Sportsman® 570 EFI Service Manual
© Copyright 2013 Polaris Sales Inc.
REAR BRAKE PAD
Touring Pad Removal
1. Elevate and support the rear of the ATV.
2. Remove the rear wheel
3. Loosen pad adjuster screw 2-3 turns.
4. Remove the two caliper mounting bolts and lift
caliper off the brake disc.
NOTE: When removing caliper, be careful not to
damage brake line. Support caliper so as not to
kink or bend brake line.
5. Push caliper piston into the caliper bore slowly using
a C-clamp or locking pliers with pads installed.
NOTE: Brake fluid will be forced through
compensating port into master cylinder fluid
reservoir when piston is pushed back into
caliper. Remove excess fluid from reservoir as
required.
6. Push caliper mounting bracket inward and slip outer
brake pad past the edge to remove.
BRAKES
To Next Page
Loading...
