10
10.17
9924871 R03 - 2014 Polaris Sportsman® 570 EFI Service Manual
© Copyright 2013 Polaris Sales Inc.
ALL WHEEL DRIVE (AWD) COIL
Operation Overview
• Switch must be set to ‘4x4’. 12Vdc power is present at the AWD hub coil.
• The instrument cluster senses grounding at pin #16. AWD icon should turn on at the instrument cluster.
• System must be grounded to operate.
Diagnosing System Failures
• Verify the AWD switch is functional.
• Verify the AWD hub coil is functional. Test the AWD hub coil using an ohm meter.
AWD Hub Coil Resistance:
24 Ω ± 5%
• Verify the wiring harness, wiring, connectors, connector pins and grounds are undamaged, clean and connect
properly.
• Verify continuity of wire connections with a known good volt/ohm meter.
NOTE: Verify all wires and wiring connections have been tested properly with a known good volt/ohm
meter before suspecting a component failure. A high percentage of electrical issues are caused by bad/
failed connections and grounds.
ELECTRICAL
To Next Page
Loading...
