TRANSMISSION
8.11
inch wrench to aid in removal.
16. Remove pinion gear retaining plate and pinion
gear assembly.
17. Inspect pinion gear for broken, chipped, or worn
teeth. Check bearing condition, and snap ring
location.
18. Loosen front output housing pinch bolts.
CAUTION: Do not lose pinch plate. Must be used for
reassembly or transmission will be damaged.
Loosen Pinch
Bolts
Pinch Bolts
19. Mark housing and casting for reference upon
reassembly.
20. Using 2 1/8 Wrench (PN 2871701) unscrew the
front drive housing from the transmission casting
until O-ring is exposed 1/2 (13mm).
NOTE: Do not attempt to unscrew the front drive
housing completely at this
time.
Enfocus Software - Customer Support
To Next Page
Loading...
