Engine / Cooling
3.39
Engine Assembly -- All Engines
7. Apply Loctitet 242 to crankcase bolts. Install and
tighten bolts to specification and sequence. Sequence
is shown on pages 3.5 to 3.8.
8. Install front and rear engine mount straps. The two
reinforcing ribs on each mount are positioned to the
rear (PTO end) of engine. Torque to specifications
listed on pages 3.5 and 3.8. The MAG end has relief for
the magneto housing. Rotate crankshaft to verify that
crankshaft rotates freely without binding.
9. Bend locking tabs flat and up against bolt heads.
10. Lubricate main bearing holes with Polaris Premium 2
Cycle engine oil and rotate crankshaft to distribute oil
evenly.
Crankcase Bolt Torque
8mm 22ft.lbs. (30Nm)
10mm 28ft.lbs. (38Nm)
Apply Loctitet 242
To Next Page
Loading...