Engine / Cooling
3.46
Engine Assembly -- All Engines
36. Apply a light film of Loctitet 262 to crankshaft taper.
Install flywheel on flywheel key.
37. Using a flywheel holder tool, PN 8700229, tighten the
flywheel nut to specification.
38. Visually inspect the stator housing to make sure wires
are not coming into contact with the flywheel or starter
drive.
39. Install oil pump drive nut on flywheel nut.
40. Place a new flywheel cover gasket on stator housing.
Install flywheel cover and torque to specification.
T ighten all bolts in a criss--cross pattern.
Flywheel Nut Torque
80 -- 100ft.lbs. (108 -- 136Nm)
Apply Loctitet 242 to Threads.
Flywheel Cover Bolt Torque
9ft.lbs. (12Nm)
Apply Loctitet 242 to Threads.
To Next Page
Loading...