Poly E Series - Page 76

76
Leave a Bridge Call
Any member in a bridge call can leave the call, and the call remains active.
After you leave a bridge call, you can rejoin by pressing the Barge In soft key again.
Procedure
 Select the End Call soft key, or place the handset in the cradle.
Your connection to the bridge call is ended, and the other call participants remain on the call.
Resume a Held MADN Call
Any MADN member can resume a held call on the shared line. When an active call is placed on hold on
the shared line, all group members are notified of the call's new status by a flashing red LED light on
the line key on all members' phones, if enabled by your system administrator.
When a held call is resumed by another MADN member, the other group members are notified of the
call's new status with a steady red LED light on the line key on the members' phone.
Procedure
 Do one of the following:
3 Select the corresponding line key and lift the handset.
3 Press and hold the corresponding line key and select Resume.
Enabling Privacy for MADN Calls
Any MADN member can temporarily enable privacy for an active or bridge call on a public shared line
using privacy codes or privacy soft keys configured by your system administrator.
Additionally, MADN members can use privacy codes and soft keys to temporarily disable privacy on an
active call on a private shared line.
The following are three types of privacy codes that you can use to enable and disable privacy on a
shared line:
 Privacy Access (PRV) code—Enables privacy for an active call on a public line.
 Privacy Release Activation (PRLA) code—Disables privacy for an active call on a private shared line.
 Privacy Release Cancel (PRLC) code—Re-enables privacy for an active call on a private shared line.
When a shared line is configured as private or when privacy is enabled on an active call, bridging is
disabled and other MADN members cannot barge in on an active call on the shared line.
Enable Privacy
After you enable privacy for an active call on a public shared line, you cannot disable privacy for the
call. You can allow other MADN members to join the active call by transferring the call or initiating a
conference call.
Procedure
 During an active call, do one of the following:
3 Select Transfer and dial the PRV code given to you by your administrator.
For example, dial *91.
3 Select the Priv soft key, if enabled.
 A confirmation tone plays and the call is resumed automatically.