Polycom RealPresence Group 310 User Manual

Polycom, Inc. 5
Using a Polycom RealPresence Group
Series Remote Control
The infrared RealPresence Group Series remote control allows you to operate a RealPresence Group
Series system.
This includes placing calls, adjusting the volume, zooming the camera, navigating screens, and more.
RealPresence Group Series systems and EagleEye cameras have infrared receivers. You can control your
RealPresence Group Series system by pointing the remote control toward a RealPresence Group Series
system or a connected EagleEye camera.
You might need a special cable to connect an SDI camera to the system to receive infrared signals from the
remote control. For more information about the cable, contact Polycom support.
This section includes the following topics:
● “Remote Control Buttons and Descriptions” on page 6
● “Contacts” on page 7
● “Calling” on page 9
● “Content” on page 15
● “Recording Calls” on page 20
● “Settings” on page 23
● “Troubleshooting” on page 33

Polycom RealPresence Group 310 Specifications

General

Network Protocols	H.323, SIP
Network Interfaces	1 x 10/100/1000 Ethernet
Video Resolution	1080p, 720p
Audio Standards	G.711, G.722, G.722.1, G.728, G.729A
Video Standards	H.263, H.263+, H.264, H.264 High Profile
Network	10/100/1000 Ethernet
Video Input	1 x HDMI
Video Output	HDMI
Audio Input	1 x 3.5mm stereo line-in
Audio Output	1 x 3.5mm stereo line-out
Other Interfaces	2 x USB 2.0
People Video Resolution	1080p
Content Sharing	People+Content IP
Security	AES
Camera	Polycom EagleEye Acoustic or EagleEye IV