Polycom RealPresence Group 310 User Manual

Using a Polycom RealPresence Touch Device
Polycom, Inc. 71
Figure 2: Connections for a RealPresence Group 700 system
Show Content from a Connected Computer
After you connect a USB cable from your computer to the RealPresence Touch, you can share content from
the computer to the RealPresence Group system monitor display.
The computer does not need a LAN connection for this feature, because content information is sent over
the USB cable connected to the RealPresence Touch. Windows and Macintosh computers are supported.
Content audio is not supported.
TASK
1 Connect a compatible USB cable from the RealPresence Touch to your computer.
2 After the USB cable is connected, the People+Content (PPCIP) application is available on one of
your computer drives, such as E or F.
3 Open the People+ContentIP.exe file to start the application.
4 When you are ready to begin showing content, do one of the following:
Out of a Call: On the RealPresence Touch, from the Home screen, tap Show Content. Then
under People+Content IP, tap Show Content.
In a Call: On the RealPresence Touch, from any screen, tap Menu, Active Call, Content. Then
under People+Content IP, tap Show Content.
Content on your computer is now displaying on the connected room system monitor.

Polycom RealPresence Group 310 Specifications

General

Network Protocols	H.323, SIP
Network Interfaces	1 x 10/100/1000 Ethernet
Video Resolution	1080p, 720p
Audio Standards	G.711, G.722, G.722.1, G.728, G.729A
Video Standards	H.263, H.263+, H.264, H.264 High Profile
Network	10/100/1000 Ethernet
Video Input	1 x HDMI
Video Output	HDMI
Audio Input	1 x 3.5mm stereo line-in
Audio Output	1 x 3.5mm stereo line-out
Other Interfaces	2 x USB 2.0
People Video Resolution	1080p
Content Sharing	People+Content IP
Security	AES
Camera	Polycom EagleEye Acoustic or EagleEye IV