Using a Polycom Touch Control Device
Polycom, Inc. 81
Disconnect a Polycom Touch Control from a
RealPresence Group System
The connection pairing with the Polycom Touch Control persists until you either disconnect or power off the
RealPresence Group system.
1 On the Home screen, touch then touch the RealPresence Group Series System tab.
2 Under Device Connection Status, touch .
3 Touch View Pairing Settings.
4 Touch Forget This Device.
The IP Address field is now blank.
Calling
There are several ways to initiate calls on the system. You can place a call by entering your contact’s name
or number, by choosing a contact in the directory, or by calling a speed dial or recent contact.
You can perform all of the functions that are available when making conventional calls, plus you can make
multipoint conference calls.
Call by Entering a Name or Number
You can place a call several different ways.
One easy way to place a call is to enter a specific name or number using a touch device or the remote
control.
Keep in mind that, depending on the capabilities of your system and the system you are calling, the dialing
information could look like one of these examples:
● 10.11.12.13 (IPv4 address—include the dots)
● 2555 (E.164 extension for H.323 or SIP)
● stereo.polycom.com (host name)
● (SIP)
1 From the Home screen, touch .
2 In the dialing field, enter the dialing information.
3 Enter any additional information needed for the call.
The available settings depend on the type of call and your system's configuration.
4 Touch to place the call.
To Next Page
Loading...
Need help?
General
