Polycom VVX 300 - Page 71

Polycom VVX Business Media Phones User Guide UC Software 5.3.0
Polycom, Inc. 71
Any member in a bridge call can leave the call, and the call remains active.
To leave a bridge call:
» Select the End Call soft key, or place the handset in the cradle.
Your connection to the bridge call is ended, and the other call participants remain on the call.
You can rejoin a bridge call after leaving by pressing the Barge In soft key again.
Hold and Resume Calls
Any MADN member can resume a held call on the shared line. When an active call is placed on hold on
the shared line, all group members are notified of the call’s new status by a flashing red LED light on all
members’ phones (if enabled by your system administrator).
To resume a call on the shared line:
» Do one of the following:
 Select the corresponding line key and lift the handset.
 Press and hold the corresponding line key and select Resume.
When a held call is resumed by another MADN member, the other group members are notified of the
call’s new status with a steady red LED light on the members’ phone.
Enable Privacy
Any MADN member can temporarily enable privacy for an active or bridge call on a non-private shared
line using privacy codes or privacy soft keys configured by your system administrator. Additionally, MADN
members can use privacy codes and soft keys to temporarily disable privacy on an active call on a private
shared line.
The following are three types of privacy codes that you can use to enable and disable privacy on a shared
line:
● Privacy Access (PRV) code Enables privacy for an active call on a non-private line.
● Privacy Release Activation (PRLA) code Disables privacy for an active call on a private shared
line.
● Privacy Release Cancel (PRLC) code Re-enables privacy for an active call on a private shared
line.
When a shared line is configured as private or when privacy is enabled on an active call, bridging is
disabled and other MADN members cannot barge in on an active call on the shared line.
To enable privacy for an active call on a non-private line:
» During an active call, do one of the following:
 Select Transfer and dial the PRV code given to you by your administrator
For example, dial *91.