G2000e/G3000e/G6000e User’s Manual Chapter 3: Operations and Settings
21
Table 3-1 LED Indicator Description
• If the indicator is on, the printer is ready and waiting for user input
• If only the [READY] indicator is blinking, then the printer is paused
and awaiting further instruction
• If the indicator is on, it means the printer is at a normal working state
• If both the [READY] and [MEDIA] indicators are blinking, then the
printer detected media out
• If the indicator is on, it means the printer is using thermal transfer
mode (Requires ribbon)
• If the indicator is off, it means the printer is using direct thermal mode
(No ribbon required)
• If both [READY] and [RIBBON] indicators are blinking, then the
printer detected ribbon out
Panel Buttons
The three buttons on the front of the printer, please refer to Table 3-2 below for details regarding
their functionality.
Table 3-2 Panel Button Description
Advanced Functions
(Press and hold for 4 seconds)
• When printer is in a standby
state, press once and the
printer would feed one label
• When printer is in an error
state, press to choose Reprint
or Print Next
• When printer is in working or
standby state, press once to
pause the printer
• When printer is in pause state,
press once to resume
Self-test:
The Printer performs a self-test and
prints out a configuration report
• During printing, press to
cancel the current print job
• When printer is in an error
state, and there is no print job
in process, press to clear the
error report
• When printer is in an error
state, and there is unfinished
print job in process, press to
cancel the print job
Reset:
Resets the printer to Factory Default
Settings
To Next Page
Loading...
