Potterton Paramount four - Operation in Wet Rooms

5.3.3 Operation in wet rooms
In the supplied status, the Paramount four conforms in case of room air-
independent operation to international protection type IPx4D (see Fig.)
In the case of installation in wet rooms, the following conditions must be
met:
Room air-independent operation
to maintain IP rating IPx4D:
Do not operate the room device or thermostat in wet rooms.
All outgoing or incoming electrical lines must be installed through ten
sion release screw fittings and fixed.
Caution
The screw fittings have to be tightened, so that no water can enter
the inside of the housing!
1 Protection area 2
2 Protection area 3
When the Paramount four is installed in bath or shower rooms in resi
dential buildings, the protection areas and minimum clearances must be
heeded.
The Paramount four complies with IP rating IPx4D (protection area 2 or
1) and may be installed in protection area 2 (refer also to the above
notes “Operation in wet rooms”).
The Paramount four may only be installed in protection area 1 if no wa
ter jets are to be expected (e.g. massage showers).
Fig.13 Clearances in bathrooms and show
er rooms
1
1
2
2
RA-0000053
5 Before installation
34 Paramount four 30 – 115 kW 7658013 - 02 - 15092016