9 Settings
9.1 List of parameters
See
Subject to system configuration, not all parameters listed in the
parameter list will be shown on the display.
To reach the end user (Eu), Commissioning (C) and Engineer
(E) setting levels:
Press the OK-Taste.
Then press the information button for approx. 3 s.
Select the circuit using the control knob.
Confirm with the OK button.
Set time and date Prog. no. Level Standard value
Hours / minutes 1 Eu 01:00 (h:min)
Day / month 2 Eu 01.01 (day.month)
Year 3 Eu 2030 (year)
Start of summertime 5 E 25.03 (day.month)
End of summertime 6 E 25.10 (day.month)
Operator section Prog. no. Level Standard value
Change Language 20 Eu English
Information
Temporarily | Permanently
22 E Temporarily
Contrast of display 25 Eu —
Operation lock
Off | On
26 E Off
Programming lock
Off | On
27 E Off
Units
°C, bar | °F, PSI
29 Eu °C, bar
Save basic settings
(1)
No | Yes
30 E No
Activate basic settings
(2)
No | Yes
31 E No
Used as, page 0
Room unit 1 | Room unit 2 | Room unit 3 | Operator unit 1 | Operator unit 2 |
Operator unit 3 | Service unit
40 C Room unit 1
Assignment device 1
(3)
Temps / mode CH1 |Central heating 1 and 2 |Central Heating 1 and 3/P |All
central heatings
42 C Temps / mode CH1
Operation CH2, page 0
Commonly with HC1 | Independently
44 C Commonly with HC1
Operation CH3/P, page 0
Commonly with HC1 | Independently
46 C Commonly with HC1
Room temp device 1, page 0
CH circuit 1 only | For all assigned HCs
47 C For all assigned HCs
Occupancy button device 1, page 0
None | Temps / mode CH1 | For all assigned HCs
48 C For all assigned HCs
Readjustment room sensor, page 0 54 E 0.0 °C
9 Settings
7658013 - 02 - 15092016 Paramount four 30 – 115 kW 57
To Next Page
Loading...
