9. COMMISSIONING
CAUTION
Only qualified personnel are allowed to commission the drive. Read and follow the safety
instructions on the first pages of this manual. Neglecting the safety instructions can cause injury or
death.
Ensure that there is no voltage present in the input power terminals and no voltage can be
connected to the drive inadvertently.
This chapter do not include all the tasks to be performed during commissioning, follow local and
national regulations.
For a properly commissioning, we recommend checking the following steps:
Check the compatibility of the upstream protections (circuit breaker, fuses,
etc...) that could cause an unexpected stop during the soft charge.
Assure that the line voltage is compatible with drive voltage range. On the
contrary, the drive could be damaged.
Connect input, PE and output power wiring, and verify that they are
correctly installed and fastened.
Check that the drive protective covers are mounted and doors are properly
closed.
Check control, and analogue and digital signals cables, functions (STO).
Potential free.
Check that the drive follows the remote and local speed commands.
To Next Page
Loading...
Need help?
General
