ION 8000 Series User Guide Default Front Panel Display Screens
Chapter 15 - Displays Page 169
events have been recorded, then the Event Log screen will indicate additional
logs exist. Refer to “Data Logging” on page 140 for more details.
4. Vector Diagram
This screen shows phasors and numeric values for each phase current and phase
voltage measurement.
5. Instantaneous Voltage
This screen shows average voltage, line-to-neutral and/or line-to-line voltage
(depending on the meter’s service type).
6. Instantaneous Current
This screen shows the phase current and average current values.
7. Instantaneous Power
This screen shows kW total, kVAR total, kVA total and signed Power Factor
total values.
8. Instantaneous Demand
This screen shows kW delivered and received from the Sliding Window (Rolling
Block) demand calculation.
9, 10, 11. Voltage Harmonics
These screens show histograms of the per phase voltage harmonic content.
12, 13, 14. Current Harmonics
These screens show histograms of the per phase current harmonic content.
15. Availability
This screen shows the availability of power in a “number of nines”
measurement, over a pre-set period of time.
16. Instantaneous Demand
This screen shows kW td delivered and received.
ALT mode Time of Use (TOU) display screens
ALT mode display screens 17 to 56 are factory-configured to show Time of Use
(TOU) data. The measurements displayed originate from frameworks of ION
modules that are linked to a TOU module. For details about the TOU module, refer
to the ION Reference.
By default, all demand values result from Sliding Window (Rolling Block)
calculations.
17. TOU Energy by Rate
This screen shows kWh delivered values for each TOU rate.
18 - 25. kW Peak Demand
These screens display the maximum kW delivered value for each TOU rate.
These values result from Sliding Window (Rolling Block) demand calculations.
26. Previous Billing Energy
To Next Page
Loading...
