Power Measurement ION 8000 Series - Using Designer

ION 8000 Series User Guide Changing TEST Mode Timeout
Chapter 16 - TEST Mode Page 179
4. Set the TEST Mode timeout to the desired time. You can choose from a numeric
bounded format or an elapsed interval format.
5. Click SEND to transmit the changes to the meter.
Using Designer
Follow these steps if you are using Designer:
1. Open Designer and connect to the desired meter.
2. Double-click the Display Setup folder on the Designer screen.
3. Right-click on the Display Options module to access the setup registers. Select
the TEST Mode Timeout setup register and click Modify to edit.
4. Set the TEST Mode timeout to the desired time. You can choose from a numeric
bounded format or an elapsed interval format.
5. Click OK to send the changes to the meter.