Power Measurement ION 8000 Series - Chapter 17 Resets; Performing a Reset; Using the Front Panel; Performing a Master Reset from the Front Panel

Performing a Reset ION 8000 Series User Guide
Page 182 Chapter 17 - Resets
Performing a Reset
Resets allow you to clear various accumulated parameters stored by the meter.
NOTE
Be sure to record any important data before performing a meter reset.
Using the Front Panel
The following resets can be performed via the front panel:
 Master Reset:
 deletes most accumulated values and all derived revenue measurements
from the meter.
 Demand Reset:
 resets the peak demand values logged in the meter.
Performing a Master Reset from the front panel
The Master Reset button is recessed to avoid accidental activation. You must first
remove the meter’s cover before you can perform a Master Reset:
1. Remove the socket-sealing ring (if applicable).
DANGER
Hazardous voltages may be present on the blades. Ensure that the power supply to the socket and/or CTs
are not present before removing the meter.
2. Disconnect the meter from the socket. Use both hands and pull the meter slowly
towards you while gently rocking the meter up and down.
VAR
MASTER
RESET
WATT
TEST
MODE