19
www.powerbox-systems.com
– The next step is to select the servos which the differential travel is to affect:
– Now briefly press the button under Diff. Value in order to set the percentage value, or to assign a transmitter control for
adjusting the value. As the screenshot shows, you can also see any Expo values which you have already set..
• Setting up differential using a fixed value:
Enter a fixed value at Diff. Value. This value can also vary according to flight phase, if you select Single at the Flight Phase
point..
• Assigning a transmitter control
Briefly press the On button after the Diff. Control field. In this example the right-hand slider has been assigned to in-flight diffe-
rential variation. Once the optimum value has been found, you can later set it as the fixed value.
• Assigning a trim
The Diff Control must be set to On. Now briefly press Diff. Trim to select one of the trims.
The trim controls are the ideal choice if you wish to set differential settings which vary for each flight phase. With this option the
differential value you set always applies to the currently selected flight phase. This only works if the button after Flight Phase is
set to Single.