42
PowerBox-Systems − World Leaders in RC Power Supply Systems
When one or more sensors is selected - as shown above - ad-
ditional functions are displayed.
4.1.5. Sensor
f you briefly press one of the values in the Sensor column, you
can place a different value at this point. Keep your finger on a
sensor name, and the following display appears:
In this menu you can change the sensor name, and see the
current sensor Address. To rename the sensor, open the
keypad by pressing the field after Alias. Note that long sensor
names, in particular, can result in extended spoken messages.
If you are using M-Link sensors, the standard M-Link-XY can
be changed to a more informative name. If you wish to restore
the original name supplied by the sensor, simply erase all the
characters in the Alias field, and confirm the empty field.
4.1.6. Menu
The Telemetry menu is an important function, since it enables
you to configure and set up sensors and other devices which
are connected to the P²BUS. An example of this is the iGyro
SAT, which can be connected to PBR receivers.
The receiver’s Setup menu can be called up by pressing the
Menu button at the corresponding sensor. The three thick
bars in the Menu column indicate whether the sensor has an
integral menu or not.
Briefly press these three bars to access the sensor’s menu.
To Next Page
Loading...
Need help?
General