PowerPac MCE400 - Maintenance; Bushings and Joints

Page 10 of 49 Instructions/Parts list Multi-Dumper MCE400 updated: 04.2021
Maintenance
• Switch off the machine before any maintenance, repair or adjustment.
• Check all visible bolts, nuts and screws regularly.
• Safety devices must never be tampered with. Check the safety device before each use.
• Keep the machine free of grass, leaves or other dirt. Clean oil or fuel contaminants. Allow the
machine to cool before storage.
• Never keep the machine near an open flame, e.g. near a water heater or furnace.
• Stop and check the device if you're driving it against something or hear strange noises from the
machine. If necessary, repair the machine before restarting.
• Only use original spare parts to ensure that the original standards are met.
Maintain the product by following a diligent program of repair and maintenance according to the
recommended procedures below. It is recommended to check the general condition of the machine
before using it. The following table is based on a normal operating plan.
Operating hours Maintenance point
Every 25 hours
1. Check all screw connections and joints and grease them.
2.
Regular greasing of the grease nipples on the pendulum
axle, as well as the steering wheels, facilitates
operation and
ensures a long service life. Any common all-
purpose grease
is suitable for this application.
3.
Check the air pressure of the tires (front max. 1.9 bar; rear
max. 2.0 bar).
Every
50 hours
1. Make sure that all functions are working properly.
2. Check all electrical components for their correct function.
3. Oil the bowden cable of the tipping
mechanism after either
50 operating hours or after moisture penetration, depending
on which situation occurs sooner.
Bushings and joints
• Bushings are subject to wear and tear and must be checked regularly. The bushings must be
replaced at the first sign of wear, otherwise costly consequential damage can occur.
• Lubricate all joints, grease nipples and moving parts of the machine at regular intervals. This
contributes to a longer life of all joints and bearings. (Pendulum axle joint, wheel axles steering
wheels, rotating axle steering wheels)