PowerPac MCE400 - Tipping the Tray; the Buildup; Standard Equipment Fig.: 10

Page 24 of 49 Instructions/Parts list Multi-Dumper MCE400 updated: 04.2021
Tipping the tray / the buildup
Standard equipment Fig.: 10
The MCE400 is equipped with a spring lock and a gas pressure spring as standard. The spring lock
prevents the tray / buildup from tipping over unintentionally. The gas pressure spring supports the
operator in tipping the tray / buildup when it is loaded.
By actuating the spring lock release lever (Pos.14) on the lower left side of the handlebar, the locking
mechanism (spring lock) of the tipping mechanism is released.
Pouring out the goods from the tray can be supported by slightly lifting the tray by hand. The independent
tipping depends on the center of gravity of the transported goods.
DANGER! If the MCE400 is unloaded and you operate the tipping lever, depending on
the equipment, the buildup will be jerked up by the gas pressure spring. Hold the tray /
buildup firmly so that it is slowly pushed into its end position.
14
Fig.: 10 – Release lever spring lock (tray / buildup)