Page 13 of 49 Instructions/Parts list Multi-Dumper MCE400 updated: 04.2021
Handlebar adjustment
The angle of the handlebar (the handles) of the MCE400 can be variated and thus precisely adjusted to
the respective body size or application.
1. Loosen the six Allen screws. Do not remove them completely! (Fig.: 3)
2. As soon as it is released, slide the handlebar either to the right or left until the angle can be
freely adjusted. The anti-twist protection is ensured by a toothed ring. You can change the angle
of the handlebar in predefined steps and adjust the handlebar perfectly to your height. In any
case, the handlebar must be pushed back into its starting position so that the ring gear (the anti-
twist device) can grip.
Fig.: 3 – Allen screws, handlebar adjustment
To Next Page
Loading...