Page 34 of 49 Instructions/Parts list Multi-Dumper MCE400 updated: 04.2021
Lifting the machine
Ignoring the following instructions could result in severe damage, accident, or death. Never lift
the Multi-Dumper MCE400 unsecured or with unsuitable tools. Always use suitable means of
transport, belts and tools. The straps must be long enough and have a tensile load of at least
2t. Use suitable machinery that can support the weight of the Multi-Dumper. Never lift the
machine with people or children on board. Only attach the straps to the lashing points provided.
If you are not sure, contact us and ask.
Problems, probable causes, troubleshooting
The machine does not move
1. Batteries are discharged
2. Controller defective
3. Defective thumb lever
4. Machine was not switched on
5. Parking brake opened
2. Contact customer service
3. Exchange thumb lever
4. The machine must be
switched on, on the left
side of the control box
using the key switch.
5. See
Parking brake (Fig.:
The machine can no longer be
switched on
1. Check the contacts on the
batteries and in the control box
2. Batteries empty
retighten them if
necessary
2. Charge batteries
2. Defective gearbox
3. Machine may be too dirty
1. Contact customer service
2. Contact customer service
The machine does not react to
any operation
The machine only travels in one
direction
1. Reverse switch defective
2. Controller defective
1. Exchange reverse switch
2. Contact customer service
Batteries cannot be charged
(The voltage of the batteries
should be > 24V when fully
charged (measured individually
2. Defective batterie/s
2. Exchange batterie/s
If your problem is not described, please contact our technical support.
DANGER! PowerPac Baumaschinen GmbH rejects any liability if the machine has not
been maintained as described in this manual and / or has not been repaired with original
spare parts.
To Next Page
Loading...