Page 21 of 49 Instructions/Parts list Multi-Dumper MCE400 updated: 04.2021
Operation
Before the use of the machine, it is necessary to attentively read this manual learning the
formalities and the procedures to operate the machine safely.
Turn on the machine
Check that the thumb lever (Pos. 13) for controlling the speed of the motor is in its neutral position. Only
then switch on the machine using the key switch (Pos. 20). After actuating the key switch - depending
on the state of charge of the battery - the light bar of the battery indicator (Pos. 19) lights up. Make sure
that the machine is fully charged or not fully discharged. If necessary, charge the machine before use.
Driving
Pressing the thumb lever (Pos. 13) sets the Multi-Dumper MCE400 in motion. The speed of the MCE400
can be adjusted variable with the thumb lever. The direction of travel (forwards or backwards) is
determined by the lever (Pos. 15) on the left side of the handlebar. If the lever is not actuated while the
thumb lever is actuated, the machine moves forward; if the lever is actuated simultaneously with the
thumb lever, the machine moves backwards. For safety reasons, reversing is only possible at low speed.
When driving, the operator has to hold both hands on the handles and guide the MCE400, while between
the two bars he dictates the direction of travel of the MCE400 by pressing left or right on foot.
• The control levers should only be operated with both hands on the handlebars.
• Do not operate the machine on public roads.
Fig.: 8 – Operation: key switch, thumb throttle, etc.
To Next Page
Loading...