Powersoft will not be held responsible for damaged speakers.
Consult the speaker manufacturer for power handling
recommendations.
Even if you reduce the gain using the amplier’s front panel
attenuation controls, it is still possible to reach full output power if
the input signal level is high enough.
A single high-power tone can damage high frequency drivers
almost instantaneously, while low frequency drivers can usually
withstand very high, continuous power levels for a few seconds
before they fail. Reduce power immediately if you hear any
speaker “bottoming out” - harsh pops or cracking distortion that
indicate that the speaker voice coil or diaphragm is striking the
magnet assembly.
Powersoft recommends that you use ampliers of this power
range for more headroom (cleaner sound) rather than for
increased volume.
1.6 Speaker Output Shock Hazard
A Class D amplier is capable of producing hazardous output
voltages. To avoid electrical shock, do not touch any exposed
speaker wiring while the amplier is operating.
This manual contains important information on operating your
Powersoft amplier correctly and safely. Please read it carefully
before operating your amplier. If you have any questions,
contact your Powersoft dealer.
To Next Page
Loading...
Need help?
General