Installation Setup
17
Powerware
®
9170
+
UPS User’s Guide S Rev B www.powerware.com
6. After rolling the cabinet to its intended position, turn all four
caster bolts counter-clockwise until the cabinet rests on the
floor. Place a plastic cap into each bolt access hole.
NOTE If the floor is uneven and the cabinet is tilted or unstable, you may
need to place a thin steel plate under a corner. Do not use the caster
bolts to level the cabinet.
7. After properly positioning and leveling the cabinet, insert power
and battery modules into the cabinet as described in “UPS
Startup” on page 63.
To Next Page
Loading...
