PR4000 9mt 4x1000W METAL HALIDE
TL073-11-02-03
01-02-2011
13. OPERATING INSTRUCTIONS
13.1 LIGHTING TOWER POSITIONING
Place the lighting tower on a flat surface, taking care not to exceed 10° of inclination.
Choose an open location and very ventilated taking care that the discharge of the exhaust gases
happens far from the work-zone.
Check that there is a complete change of air and the hot air expelled don’t circulate into the group
in way that it’s caused a dangerous elevation of the temperature.
Predispose the barriers placed to 2 meters of distance around the lighting tower in order to prevent
to the staff non-authorized to approach itself the machine.
13.2 CONNECTING OF THE BATTERY
The machine is supplied with the battery connected at battery switch disconnect.
Connect the battery switch (20).
13.3 EARTHING
Connect the unit to the earth, through the clamp (18).
The unit must be connected to earth using a copper cable with a minimum cross-section of 6 mm².
The manufacturer is not responsible for any damage caused by failure of the earthing.
13.4 PRELIMINARY CHECKS
At the moment of purchase, the machine is supplied of engine oil, hydraulic oil and coolant in the
radiator.
Before every next use, verify the relative levels.
Check that the circuit breakers (32-33-35-36) placed on the frontal board are in “OFF” position.
Make sure that the emergency stop button (19) is rearmed. If it doesn’t, turn the grip handle in
clockwise direction.
13.5 ENGINE STARTING
The principal commands of the lighting tower are placed inside a cabinet provided of a handle with
safety lock to prevent that the unauthorised personal handlings the commands.
Position the starting key (29) on the first step to avoid the glow plugs’ pre-heating, signal lamp (26)
burnt. When the light (26) is off, start the engine by moving key (29) completely in clockwise
direction.
Note: If the engine falls to start, turn the key to the OFF position and wait 10 seconds before
operating the starter again.
Let the engine to run for about 5 minutes to warm it up.
The engine is set at (1500 r.p.m.) therefore it is not necessary to make any adjustment.
To Next Page
Loading...