PR POWER PR4000 - Replacement of Fuel Pre-Filter; Cleaning the Fuel Filter Pot

PR4000 9mt 4x1000W METAL HALIDE
38
TL073-11-02-03
01-02-2011
14.1 REPLACEMENT OF FUEL PRE-FILTER
Replace the fuel pre-filter with new one every 50 operating hours or so.
Operations:
• Unloose the two clamps with a screwdriver.
• Replace the filter respecting the sense of assembly and tighten the clamps.
• Air-bleed the injection pump if necessary.
(1)
(2)
Fuel pre-filter.
Clamp.
14.2 CLEANING THE FUEL FILTER POT
Every 100 hours of operation, clean the fuel filter. And so on in a clean place to prevent dust
intrusion.
Operations:
• Remove the top cap, and rinse the inside with diesel fuel.
• Take out the element, and rinse it with diesel fuel.
• After cleaning, reinstall the fuel filter, keeping out of dust and dirt.
• Air-bleed the injection pump.
(1)
Fuel filter pot.
1
2
1