PR4000 9mt 4x1000W METAL HALIDE
TL073-11-02-03
01-02-2011
• Apply a film of oil to the gasket for the new cartridge.
• Screw in the cartridge by hand. When the gasket contacts the seal surface, tighten the
cartridge enough by hand. Because, if you tight the cartridge with wrench, it will be
tightened too much.
• Add new engine oil up to the upper limit of the oil level gauge.
• After the new cartridge has been replaced, the engine oil level normally decreases a little.
Thus, run the engine for a while and check oil leaks through the seal before checking the
engine oil level. Add oil if necessary.
SAE 30 - SAE 10W-30 - SAE 10W-40
SAE 20 - SAE 10W-30 - SAE 10W-40
SAE 10W - SAE 10W-30 - SAE 10W-40
• NOTE: Wipe off any oil sticking to the machine completely.
14.7 RADIATOR
• Coolant will last for one day’s work if filled all the way up before operation start. Make it a
rule to check the coolant level before every operation.
WARNING:
• To avoid personal injury do not remove the radiator cap when the engine is hot. Then
loosen cap slightly to the stop to relieve any excess pressure before removing cap
completely.
• Do not stop the engine suddenly, stop it after about 5 minutes of unloaded idiling.
• Work only after letting the engine and radiator cool off completely (more than 30 minutes
after it has been stopped).
• If the machine has to be stopped for a long period (more than one year), we suggest to
keep the coolant into the radiator in order to avoid oxidizing effects.
To Next Page
Loading...
