PR POWER PR4000 - Changing Engine Oil and Replacing the Oil Filter Cartridge

PR4000 9mt 4x1000W METAL HALIDE
41
TL073-11-02-03
01-02-2011
14.6 CHANGING ENGINE OIL AND REPLACING THE OIL FILTER CARTRIDGE
• CAUTION: To avoid personal injury be sure to stop the engine before draining the engine
oil and the oil filter cartridge and allow engine to cool down sufficiently; oil can be hot and
can burn.
• For change the engine oil, it was predisposed a manual pump.
(1)
(2)
Engine oil drain cap.
Manual pump in order to extract the oil from
the engine
Operations:
• Take a container for the exaust oil, remove the discharge cap (1) from the pump (2) and
pump out the oil. Drain oil easier and completely while the engine is tepid.
• WARNING: after using the pump screw well the cap (control the tightening before
each engine stating).
• Contact with engine oil can damage your skin. Put on gloves when using engine oil. If you
come in contact with engine oil, wash it off immediately.
• Change oil after the initial 50 hours of operation and every 200 hours thereafter.
• Do not discharge the polluting liquids in the atmosphere.
• Detach the old oil filter cartridge with a filter wrench.
(1)
Oil filter cartridg.
Remove with a filter wrench (tighten with
your hand).
2
1
2
1
1