PR4000 9mt 4x1000W METAL HALIDE
TL073-11-02-03
01-02-2011
14.4 ENGINE OIL
• CAUTION: To avoid personal injury, be sure to stop the engine before checking the oil
level, changing the oil and the oil filter cartridge.
• Contact with engine oil can damage your skin. Put on gloves when using engine oil. If you
come in contact with engine oil, wash it off immediately.
• NOTE: Be sure to inspect the engine, locating it on a horizontal place. If placed on
gradients, accurately, oil quantity may not be measured.
14.5 CHECKING LEVEL AND ADDING ENGINE OIL
Operations:
• Check the engine oil level before starting or more than five minutes after stopping.
• Detach the oil level gauge, wipe it clean and reinstall it.
• Take the oil level gauge out again, and check the oil level.
(2)
(A)
Oil level gauge.
Engine oil level within this range is proper.
• If the oil level is too low, remove the oil filter plug and add new oil to the prescribed level.
• After adding oil, wait more than 5 minutes and check the oil level again. It takes same time
for the oil to come down to the oil pan.
To Next Page
Loading...
