EasyManua.ls Logo

PR POWER PR4000 - Changing Coolant

PR POWER PR4000
75 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
PR4000 9mt 4x1000W METAL HALIDE
44
TL073-11-02-03
01-02-2011
(1)
Coolant drain cock.
IMPORTANT: If the radiator cap has to be removed, follow the caution above and securely
retighten the cap.
Use clean water and anti-freeze to fill the reserve tank.
If coolant should be leak, consult your local Kubota dealer.
Do not refill reserve tank over the “FULL” level mark
Be sure to close the radiator cap securely. If the cap is loose or improperly closed, coolant may
leak out and decrease quickly.
14.9 CHANGING COOLANT
Operations:
To drain coolant, always open both drain cocks and simultaneously open the radiator cap
as well. With the radiator cap kept closed, a complete drain of water is impossible.
Remove the overflow pipe of the radiator pressure cap to drain the reserve tank.
Radiator capacity 3,1 l.
PRECAUTION AT OVERHEATING
In the event the coolant temperature is nearly or more than the boiling point (lamp (25) placed on
the command panel), the engine’s protection (DAS) turns off the engine after about 20 seconds.
Take the following actions:
Do not open the hood and any other part.
In case of steam blown out, keep yourself and others weel away from the engine.
Let the motor to cool and, checked that there gets no danger such as burn, get rid of the
causes of overheating according to the manual, see “TROUBLESHOOTING” section.
1

Table of Contents

Related product manuals