Turn off engine ignition.
Turn off the two RCD's.
Allow the engine to cool down.
Turn off ALL lamp circuit breakers.
SWITCHING OFF LAMPS
LAMP OPERATION
Switch the two RCD's to the ON position.
Switch on the first lamp circuit breakers and allow it to warm up.
Switch on the ramaining lamp circuit breakers, allowing each one
to warm up, before operating the next.
To tilt the lamps operate the Light Inclination Lever, located on
the Control Panel.
on the Control Panel.
Engage the locking pin to secure the mast into position.
To raise or lower mast, operate the Mast Control Lever, located
manually, to the desired position.
To rotate the mast, disengage the locking pin and rotate the mast
of the mast) is engaged.
Before operating the mast, ensure the locking pin (located at the base
MAST OPERATION
Allow engine to reach correct operating temperature, before continuing.
BEFORE STARTING THE ENGINE
iii. Turn ignition to the ST position to start.
ii. Turn ignition to the GL position and wait 10 seconds.
i. Turn ignition to the ON position.
To start the engine:
Ensure ALL lamp circuit breakers are in the OFF position.
Ensure the two RCD's are in the OFF or TRIPPED position.
Check engine oil, coolant and fuel levels (top up as required).
other hazards/obstructions.
Ensure the lighting tower is positioned away from powerlines and
4.
2.
3.
1.
1.
4.
3.
2.
4.
3.
2.
4.
5.
1.
1.
2.
3.
6.
Ensure handbrake on drawbar is locked in position.
Ensure ALL stabiliser legs are fully deployed and locked in position.
Check the spirit levels (located on top of the canopy) for correct levels.
Ensure the lighting tower is positioned on level ground.
Read the PR4000 Operating Manual, before operating the equipment.
PRE-START CHECK
OPERATION INSTRUCTIONS
2.
4.
5.
3.
1.
Lamp voltage: 240V - 50 Hz
Lamp current: 9,5 ÷ 10,5 A
Lamp: NARVA-G.L.E. NACHROMA NCT 1000 W
or similar with the following characteristics:
In case of replacement of the lamps use:
Type of lamp: METAL HALIDE
Nominal power: 1000W
Base: E40
ATTENTION!
To Next Page
Loading...
