Pratica Copa Express - Page 85

79
The following table shows the description of each status as well as the indication in HMI display.
P006
Status
HMI
Description
0
READY
Indicates the inverter is ready to be enabled.
1
RUN
Indicates the inverter is enabled.
2
SUB
Indicates the incoming voltage is too low for
operation (under voltage) and will not accept the
enabling command.
3
FAULT
The inverter will flash the fault code on the screen
when there is a problem.
4
NOT USED
-
Without indication.
5
CONFIGURATION
Indicates the inverter has an incompatible program
for the parameter. After pressing the key, it will
keep showing an arrow until the incorrect setting is
corrected, as shown in the figure.
When a failure occurs, the frequency inverter will flash the code on the screen and will prevent
the blower motor from operating.