A26361-K878-Z102-2-7619 57
7 Troubleshooting and Tips
V CAUTION!
Observe the safety information in the „Security and Ergonomics“
manual and in chapter “Important Notes” on page 11.
If a problem occurs, try to resolve it as described:
– in this chapter,
– in the documentation for the attached devices,
– in the help systems of the software used.
If you fail to correct the problem, proceed as follows:
Ê Make a list of the steps and the circumstances that led to the fault. Also make
a list of any error messages that were displayed.
Ê Switch off the server.
Ê Contact our customer service team.
7.1 Power-ON Indicator Remains Dark
The power-ON indicator remains dark after you switch on your device.
Power cord incorrectly connected
Ê Make sure that the power cable is correctly connected to the server and to
the grounded socket.
Power supply overloaded
Ê Pull the server power plug out of the power socket.
Ê Wait a few seconds before you plug it into the grounded socket again.
Ê Switch on your server.
To Next Page
Loading...
