A26361-K878-Z102-2-7619 39
5 Preparation for Use and
Operation
V CAUTION!
Please note the safety instructions in chapter “Important Notes” on
page 11.
5.1 Switching the Server ON and OFF
V CAUTION!
If after switching ON the server there is nothing but flickering stripes on
the screen, switch the server OFF immediately (see section “Flickering
Stripes on the Monitor Screen” on page 59).
The ON/OFF button does not disconnect the server from the mains. To
disconnect from the mains completely, remove the power plug.
Switching the server ON
– First system installation:
Ê Press the ON/OFF button (position 6 in figure 16 on page 42).
Power-on indicator (position 7 in figure 16 on page 42) lights green.
Ê Insert the ServerStart-CD and/or an installation disk in the corresponding
drive.
Ê Configure the server and install the operating system.
I Further information is provided in the section 5.2 on page 41. A
detailed description can be found in the „ServerStart Bundle“
manual.
– System already installed:
Ê Press the ON/OFF button (position 6 in figure 16 on page 42).
The server is switched on, performs a system test and boots the
operating system.
To Next Page
Loading...
