A26361-K878-Z102-2-7619 41
Preparation for Use and Operation Configuring the Server
5.2 Configuring the Server and Installing the
Operating System
This section contains information about configuring the server and installing the
operating system.
I Make sure that the energy saving functions are disabled in the BIOS Setup
(„D1570 Setup Utility for RX200“) during server operation.
5.2.1 Configuration with ServerStart
With the ServerStart-CD provided, you can configure the server and install the
operating system in a convenient manner.
The menu-guided configuration includes the server configuration with the SCU
and the RAID controller configuration with the GAM (Global Array Manager)
and/or Adaptec Storage Manager.
To find out how to operate ServerStart and for further information, refer to the
„ServerStart Bundle“ manual (see “Related Publications” on page 69).
5.2.2 Configuration without ServerStart
Configuring the PCI RAID controller
Configure the PCI RAID controller as described in the related documentation
(see “Related Publications” on page 69).
Installing the Operating System
Ê Insert the installation floppy disk and the CD for the operating system you
want to install into the corresponding drive.
Ê Reboot the server.
Ê Follow the instructions on the screen and in the manual for the operating
system.
I Please read how to install the desired operating system in the related
manual for the RAID controller.
To Next Page
Loading...