60 A26361-K878-Z102-2-7619
Floppy Disk Cannot be Read and/or Written Troubleshooting and Tips
Mouse controller disabled
The mouse controller on the system board must be enabled if you use the
supplied mouse.
Ê Check in the „D1570 Setup Utility for Rx200“ that the mouse controller is
Enabled.
7.7 Floppy Disk Cannot be Read and/or Written
Ê Check whether the write protection for the floppy disk is activated.
Ê Check the entry for the floppy disk drive in „D1570 Setup Utility for Rx200“.
7.8 Incorrect Time and/or Date
Ê Set the time and/or date in the operating system or in „D1570 Setup Utility
for Rx200“.
I If the time and date are repeatedly wrong when you switch on your
server, you must change the lithium battery. Contact our Service group.
7.9 System Will Not Boot
The system will not boot after installing a new hard disk drive.
Incorrect SCSI configuration (Ultra Wide SCSI Controller)
Ê In the SCSI configuration menu check the settings for the hard disk drives
(SCSI Device Configuration) and the settings under Advanced Configuration
Options.
To Next Page
Loading...