Prinoth BISON X - User Manual

252 pages

Save Page as PDF

To Next Page

To Next Page

Loading...

41237353 | REV01

Operating and maintenance

manual for the

BISON

BISON X

snow groomer

Vehicle numbers

908930245 to 908930367

Table of Contents

Questions and Answers

J
Juan RogersAug 8, 2025
What to do if Prinoth DJ Equipment engine does not start or cuts out straight away?
- D
  Dr. Denise GilbertAug 8, 2025
  If your Prinoth DJ Equipment's engine doesn't start or cuts out immediately, there might be several reasons. It could be due to an empty fuel tank, in which case you should fill it up. Alternatively, the fuel filter or pre-filter might be blocked, requiring you to replace the filter insert. Water in the fuel pre-filter can also cause this issue; remove the water. Leaks in the fuel system or filter necessitate replacing the seals. Also, ensure you're using cold-resistant fuel and the correct engine oil viscosity suitable for the operating conditions. Clean or replace the fuel pre-filter and use winter fuel if necessary.
P
Patrick WilliamsAug 21, 2025
Why Prinoth DJ Equipment starter pinion does not turn or turns too slowly?
- D
  Dr. Andrew Gutierrez MDAug 22, 2025
  If the starter pinion in your Prinoth DJ Equipment doesn't turn or turns too slowly, it could be due to a few reasons. Firstly, check if the battery is sufficiently charged and charge it if needed. Also, ensure the starter connection cable is not loose; tighten the cable at the terminal, and if necessary, weld on a new terminal. If these steps don't resolve the issue, the starter solenoid or starter might be defective, in which case you should arrange an inspection by a specialist workshop.

Prinoth BISON X Specifications

General

Brand	Prinoth
Model	BISON X
Category	DJ Equipment
Language	English

Related product manuals