EasyManua.ls Logo

Prinoth BISON X - Battery; Safety Instructions

Default Icon
252 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
NOTICE
Risk of damage
Components
may be damaged if the water pressure or air pressure is too high. Chemical substances
can corrode the alloys in components.
Only use moderate pressure when cleaning.
Keep the water or air jet moving constantly.
Do not use caustic soda, hydrochloric acid, or chemicals for cleaning.
NOTICE
Risk of damage
Water
and pressure may cause damage to electrical and electronic components and therefore cause
the failure of entire systems.
Switch off electrical systems before cleaning the engine.
Do not use too much pressure or water.
Do not aim the water jet directly at electrical components, connectors, seals, tubes, etc.
Do not wash the alternator, starter, or electrical control unit.
Follow the manufacturer's instructions.
Maintain a minimum distance between the high-pressure nozzle and the object being cleaned:
For needle jet nozzles approx. 70 cm (28 in)
For 25° flat-jet nozzles and mud cutters approx. 30 cm (12 in)
Battery
Safety instructions
Observe the following safety instructions when handling batteries:
WARNING
Risk of caustic burns
The acid contained in the batteries causes caustic burns to skin and eyes.
Avoid contact with skin, eyes, or clothing.
Wear suitable protective clothing, protective gloves and safety goggles.
If splashed with acid, wash off immediately with clean water and seek medical assistance if nec-
essary.
Battery acid should be stored out of reach of children.
WARNING
Explosion hazard
Gases leaking from batteries may explode and cause injury.
Keep away from fire, naked flames and sparks, and do not smoke.
Operating and Maintenance Manual
Snow groomer BISON
172
(255)
11 - Maintenance
BISON 908930245 - 30367
11.11
11.11.1

Table of Contents

Related product manuals