Prinoth BISON X - Wheels; Check Tension Wheels, Running Wheels and Sprocket Wheels

■ Once
the bowl is full, hold the switch for 30 s to fill the other filters and lines (fuel pressure can be
seen on the display in the cab, pressure must raise to 2 bar minimum otherwise there is still air
bubbles in the system);
■ Wait one minute and hold the switch a second time for 30 s;
■ Wait one minute and hold the switch a third time for 30 s;
■ Start the diesel engine.
When starting, do not crank for more than 20 s as this could cause permanent damage to engine com-
ponents.
If the engine fails to start, wait two minutes before cranking again. Before making an other try, investi-
gate for a possible problem. Check the display in the cab to see if a diagnostic or event code helps to
pinpoint the problem.
When the system is properly purged, the fuel pressure should reach 2 bar within 5 s of the switch acti-
vation. If it takes 10 s or more, air could still be trapped in the system.
Wheels
Check tension wheels, running wheels and sprocket wheels
1
2
3
Figure 109: Tension wheels, running wheels and sprocket wheels
Pos. Name
1 Tension wheels mounting torque : 340 Nm (250 ft-lb)
2 Running wheels mounting torque : 230 Nm (170 ft-lb)
3 Drive sprockets mounting torque : 145 Nm (107 ft-lb)
NOTICE
► Check wheel nuts after the first 40 operating hours and tighten if required.
■ Check the tension wheels (1) and running wheels (2)
□
Check tightening torque of the mounting nuts.
□ Carry out visual check of tyres and wheel rims.
□ Check tire walls for damage.
Snow groomer BISON
Operating and Maintenance Manual
BISON 908930245 - 30367
11 - Maintenance
185 (255)
11.14
11.14.1