Cleaning the hydraulic hoses
■ Clean the hydraulic hoses and lines with a warm water jet, or using compressed air and ben-
zine.
■ Blow out hydraulic hoses and lines with dry compressed air after cleaning.
■ Fit protective caps to hydraulic hoses.
Damaged hydraulic hoses
If a hydraulic hose bursts, proceed as follows:
1. Switch off engine immediately.
2. Locate damaged hydraulic hose.
3. Slowly open the union nut to release the pressure.
4. Collect the hydraulic oil in a suitable container.
5. Close off the damaged hydraulic hose with a sealing plug.
6. Replace the damaged hydraulic hose.
Replacing halogen lamps
CAUTION
Danger of explosion
Incorrect connection can lead to explosions and cause injury.
►
Before starting the replacement work, switch off the power supply to the headlamp.
► Wear protective gloves and safety glasses.
CAUTION
Risk of injury
Halogen lamps are under high voltage and get very hot.
►
Do not interrupt the connecting cable to the headlamp.
► When replacing lamps, always wear safety goggles and protective gloves.
CAUTION
Risk of splintering
Halogen lamps are under high pressure.
►
If a halogen lamp bursts in an enclosed space, leave the area and allow to ventilate for at least
20 min, as the escaped gases are harmful to health.
NOTICE
Risk of pollution of the environment
Halogen lamps should not be treated as normal household waste.
►
Dispose of faulty halogen lamps according to regulations.
When replacing halogen lamps, follow the instructions below:
■ Switch off headlamps and disconnect the power supply.
■ Ensure that the halogen lamp has cooled down.
■ Never touch the halogen lamp with your hands, always hold them by the base instead.
Snow groomer BISON
Operating and Maintenance Manual
BISON 908930245 - 30367
11 - Maintenance
191 (255)
■
■
11.17
To Next Page
Loading...