-19-
3. Installing the Printer
3.1. Choose a location
The iCUBE printer should be placed on a properly levelled worktable or cabinet which
is able to handle the printer’s weight and minimum 62 cm (24,4 inch) wide.
3.2. Unpacking and Setup
The printer is shipped in a strong cardboard or wooden box. Before opening the box,
check that the box is not damaged in any way and was not turned upside down during
shipment. If signs of damage are found, contact your reseller and inspect the box together.
If the box is undamaged, carefully cut the tape on the box, open the box. Before taking
the printer out of the box, make sure a strong and level work surface is prepared for the
printer.
NOTE: The printer is heavy. Never attempt to lift and take it out of the box on your own as it
can cause lasting injuries. The printer should always be lifted by two persons.
Place the printer on the desk and inspect that no damages are found on the unit.
Unpack the unwinder and the optional rewinder units and place them on the desk next
to the printer.
3.3. Checking the contents
Check the parts list to ensure you have received all required components. If the shipment
is complete, proceed to the next chapter.
iCUBE Printer
1 set of CMYKK ink cartridges (5 cartridges per set)
1 printhead
1 mains power cable
To Next Page
Loading...
Need help?
General