-87-
6.4. iCUBE Troubleshooting Guide
GENERAL
Documents to read before (available on ftp)
Print engine:
•
OEM Setup and Operations Guide
•
OEM Troubleshooting Guide
•
OEM Service and Repair Guide
•
Technical Specifications
iCUBE:
•
Training – software module
•
Troubleshooting Flowchart
•
SSC Release Notes
Checklist before doing any support
•
Firmware is 20130329/ 120524_f (/ 120209_h)
•
Driver is R12
•
Print engine is MR
•
USB AB cable is attached to print engine
•
TTL cable is attached to print engine
•
Preventive maintenance is done / sensors are clean
•
KWS = default (3)
•
NVM pages_per_cut = -1
•
NVM Mpcarev 5
•
NVM wiper motor E
•
NVM pump motor B
•
.NET 3.5, 4 is installed
To Next Page
Loading...
Need help?
General