Printing Innovation iCUBE 1 User Manual

-73-
Cutter Inspection and Cleaning
WARNING! – To avoid personal injury, power off the printer before performing this task!
1. Fold a damp lint-free cloth and insert it into the groove beneath the cutter
Pictures of cleaning the Cutter
2. Wipe back and forth to remove aerosol and debris
3. Remove any media debris from the cutter with tweezers.
5.2.5. As Needed Maintenance Tasks
The following general maintenance tasks should be performed on an as needed basis,
based upon inspection during every day use and/or when performing other tasks.
The printhead cartridge should be manually wiped after the following occurrences:
• after paper jams
• before re-installing an used printhead cartridge into the print engine
• if print quality is showing signs of contamination
• If automated maintenance algorithms prove ineffective for nozzle recovery. There
are two methods for cleaning the print head cartridge; one with it installed and one with it
removed from the unit. Both methods are listed below. When removing and reinstalling
used printhead or when replacing a printhead, use the second method.
Printhead Cartridge Cleaning (Manual Wipe While Installed)
Perform the following steps to ensure proper printhead cleaning without removing it:
1. Pinch the clamshell latches to release. Open the clamshell and allow the upper
portion to rest on the hard stops.

Printing Innovation iCUBE 1 Specifications

General

Brand	Printing Innovation
Model	iCUBE 1
Category	Label Maker
Language	English