-89-
Dead engine: When is a print engine dead?
After Dediprog re-flash, the putty output is empty or not interpretable, green LED is off.
EWS: How can I reach the print engine information page?
Open the Toolbox.
Firmware: How can I burn the firmware?
All firmware has a Readme file. Usually that file has a ddetailed description about the
firmware burning. The firmware burning is working step by step. mech_state of the engine
should return STANDBY before running Step 2 and Step 4!
If the engine is not starting, or the Toolbox can’t see
The best for the next parts to use TTL usb cable also!
Engine IP address dropout
How to detect:
net_myIP
Engine MAC address dropout
How to detect:
net_MAC_addr
does not return 010101010101
How to fix:
net_MAC_addr 010101010101
Firmware dropout
How to detect:
After starting the engine PuTTY returns:
ABCDGK012LMNPQRST
BootCode: Ver = 2010-2-23, v.1 program:28, platform:1 Processor speed 650,
Memory Size 67108864, ASIC ID 0x1162620
How to fix:
Burn the firmware by running
Step 3; Step 4
OR
Re-flash with DediProg, than adjust NVM getset, IP and MAC address settings.
To Next Page
Loading...
Need help?
General