16
The battery is fully charged when the Power LED Indicator turns from amber to green
Loading the Media
Open the printer media cover by pressing down on the media cover release latch.
Pull the media holders apart far enough to fit the width of the label roll you are installing
Place the roll, printing side face-out, between the media holders and insert hubs into the core. Pull
out enough paper above the printhead
Press down on both sides of the media cover to ensure it is closed correctly.
Note: Calibrate the gap/black mark sensor when changing media using the Configuration Utility –
Printer Function – Calibrate Sensor or the Power-On Utilities.
To Next Page
Loading...
