SAFETY
UM-PSPC-06-E/10-2012 USER MANAUL PSPC Page 17 of 99
SAFETY REGULATIONS
Do not use the system when safety devices have been removed. This system may contain sharp
edged parts, moving parts and rotating parts.
When protective covers are removed, sharp edges and pinch points may be exposed. Use extreme
caution and avoid touching or striking these areas with your hands or body because they may cause
injuries.
Do not enter parts of your body or objects into openings in the system. This may lead to serious
physical injury or damage to the system. It is dangerous to be in, on or under the system while it is
operational.
Loosely hanging clothing, wide sleeved clothing, ties, chains or rings are prohibited. Long hair should
be worn tied back.
Make sure that there is sufficient light around the machine.
Do not touch or come near moving or rotating parts. Physical contact with these parts is dangerous.
Do not stand or walk on any of the system parts.
Do not work alone on the system. At least one other person should be present
Before starting to clean, maintain or inspect the machine or before remedying breakdowns follow the
steps mentioned below:
- Switch off the machine and secure it against accidental switching on.
- Post “Do not switch on” warning sign on the main switch:
- Operate the nearest emergency button.
- Make sure that no components are moving.
Before switching on the machine, you must check the following:
- All safety devices are in place and are functioning.
- No other persons are in, underneath or above the system.
- No tools or objects are in the system.
- No other persons are at risk.
Do not use water to clean electricity cabinets and other electronic components.
For save and easy operation keep the area and floor around the machine clean, free of oil, grease or
obstacles. Remove superfluous fat and greasing oil after greasing duties.
When an extension cable is used for power supply, make sure that the cable diameter in relation to
the length of the cable is correct. Make sure the cable is completely unrolled
Manual activation of safety switches is forbidden.
When the safety devices are put out of operation, the machine must first be switched off and secured
against accidental switching on.
Work inside the electrical cabinet may only be undertaken by skilled personnel like Prinzen service
engineers or its dealers service engineers.
Always switch off the main switch before opening electrical cabinets.
After switching off the main switch, parts inside the electrical cabinet remain live for approximately 1
minute. The frequency inverters may hold a high voltage charge during this time. Do not touch parts
inside the electrical cabinet as long as displays of frequency inverters are on.
To Next Page
Loading...
