Prinzen PSPC30 - Lubrication and Maintenance Schedules

MAINTENANCE
Page 72 of 99 USER MANUAL PSPC UM-PSPC-06-E/10-2012
RECOMMENDED LUBRICANTS
Prinzen uses Interflon Fin Food Lube Teflon spray and Griffon HR260 Silicone spray. See below table
for alternative lubricants and their manufacturers. On the websites of the manufacturers you can find a
local dealer for your desired lubricant.
Component:
Lubricant:
Supplied in:
Brand:
Food grade:
Chains
Rod ends
Guides
Bronze plain bearings
Fin Food Lube
Aerosol
www.interflon.com
Interflon
Yes
Fin Lube TF
Aerosol
No
TF089 PTFE spray
Aerosol
www.griffon.nl
Griffon
No
Klüberoil 4NH1 4-220N
Aerosol
www.klueber.com
Klüber
Yes
Klüberoil CM 1-220
Aerosol
No
Cassida PL (Cassida FL5)
Aerosol
www.fuchs.com
Fuchs
Yes
Gleitmo 985
Aerosol
No
Plastic guides
Plastic plain bearings
HR260 Silicone spray
Aerosol
www.griffon.nl
Griffon
No
UNISILKON M 2000
Aerosol
www.klueber.com
Klüber
Yes
Cassida Silicone fluid spray
Aerosol
www.fuchs.com
Fuchs
Yes
Stabylan SI 210
Aerosol
No
ATTENTION!
When you want to use different types of lubricants than the lubricants used by Prinzen, make sure that these
lubricants do not form a harmful product when contacting the lubricants used by Prinzen.
NOTE!
Use H1 classified lubricants. These lubricants are approved to use in the food processing industry.
NOTE!
Residues of lubricant must be discharged as chemical waste.
TIP!
Prinzen uses Interflon Fin Food Lube Teflon spray and Griffon HR260 Silicone spray