OPERATION
UM-PSPC-06-E/10-2012 USER MANAUL PSPC Page 43 of 99
LOCAL BUTTONS
For easy control of the system, some buttons
are positioned very close to the unit that they
control. These buttons are: Denester selection
switch and stamping unit selection switch.
Denester selection switch:
When the denester is switched OFF, no
denester is used. No trays are supplied on the
output conveyor towards the tray set position.
When the denester is switched ON, the
denester is working automatically. Depending
on the selected tray type (tray selection switch)
on request of the output conveyor, the
denester supplies the appropriate tray towards
the tray set position.
For adjustment and test purposes it is possible
to manually control the denester by turning the
denester selection switch to INCH.
When the system is started, selecting INCH
results in the supply of a tray onto the output
conveyor.
When the system is stopped and the selection
switch is set to INCH the denester starts to
move. When the switch is released it turns
back to the OFF position and the denester
stops.
Stamping unit selection switch:
This button is only present on systems that are
equipped with the stamping unit.
When stamping is switched to 0, the stamping
unit is not used. Eggs leave the system without
a code.
When stamping is switched to 1, the stamping
unit is used and eggs leave the system coded.
To Next Page
Loading...
